Dell PowerVault 110T DLT VS80 Quick Start Guide - Page 21
Configuring Your System Remotely
View all Dell PowerVault 110T DLT VS80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Configuring Your System Remotely Special Administration Console (SAC) NOTE: Using SAC requires a female-to-female serial console cable to connect directly from a client system to the PowerVault storage system's serial port, as shown in Figure 2-1. Figure 2-1. Using the Console Cable to Connect to SAC NOTE: Ensure that the terminal emulation software settings on the client system are set to 115200 baud, 8 data bits, No parity, and 1 stop bit. In a non-DHCP environment, use command-line interface (CLI) support in SAC to connect (through a serial port) to a system running Windows Storage Server 2003. Then, configure network settings. After you configure the Configuring Your System Remotely 21
Configuring Your System Remotely
21
Configuring Your System Remotely
Special Administration Console (SAC)
NOTE:
Using SAC requires a female-to-female serial console cable to connect
directly from a client system to the PowerVault storage system’s serial port, as
shown in Figure 2-1.
Figure 2-1.
Using the Console Cable to Connect to SAC
NOTE:
Ensure that the terminal emulation software settings on the client system
are set to 115200 baud, 8 data bits, No parity, and 1 stop bit.
In a non-DHCP environment, use command-line interface (CLI) support in
SAC to connect (through a serial port) to a system running Windows Storage
Server 2003. Then, configure network settings. After you configure the