Dell PowerVault 210S Dell PowerVault 20xS Storage System Documentation Up - Page 2

washer and push them through the front vertical rail of the rack and into the two

Get Dell PowerVault 210S PDF manuals and user guides View all Dell PowerVault 210S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

2. If the two adjustable rail mounting flanges are not already attached to the support rails, attach one flange to one of the support rails using two 10-32 x 1/2-inch Phillips-head screws, as shown in Figure 1. Do not tighten the screws at this time. If the two rail mounting flanges are already attached to the support rails, ensure that the two 10-32 x 1/2-inch Phillips-head screws are slightly loose, allowing the flanges to slide freely. support rail adjustable rail mounting flange )LJXUH$GMXVWDEOH5DLO0RXQWLQJ)ODQJH 3. Place the flange of the support rail assembly behind the right front vertical rail of the rack. Thread two 10-32 screws with a flat washer and a square alignment washer and push them through the front vertical rail of the rack and into the two center-most screw holes of the rail mounting flange (see Figure 2). Ensure that the rail is centered vertically within the 3U mounting area. Tighten the screws. Ensure that the full surface of the support rail flange comes in contact with the surface of the vertical rail.

  • 1
  • 2
  • 3
  • 4
2.
If the two adjustable rail mounting flanges are not already attached to the support
rails, attach one flange to one of the support rails using two 10-32 x 1/2-inch
Phillips-head screws, as shown in Figure 1. Do not tighten the screws at this
time.
If the two rail mounting flanges are already attached to the support rails, ensure
that the two 10-32 x 1/2-inch Phillips-head screws are slightly loose, allowing the
flanges to slide freely.
)LJXUH²¶·²²$GMXVWDEOH²5DLO²0RXQWLQJ²)ODQJH
3.
Place the flange of the support rail assembly behind the right front vertical rail of
the rack. Thread two 10-32 screws with a flat washer and a square alignment
washer and push them through the front vertical rail of the rack and into the two
center-most screw holes of the rail mounting flange (see Figure 2). Ensure that
the rail is centered vertically within the 3U mounting area.
Tighten the screws. Ensure that the full surface of the support rail flange comes
in contact with the surface of the vertical rail.
support rail
adjustable rail
mounting flange