Dell S2810dn Dell Smart Printer Users Guide - Page 148
Ethernet, TCP/IP, To con TCP/IP settings.
View all Dell S2810dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
WPS Setup PIN Code Push Button Configuration PIN Code Print PIN Code Reset PIN Code Configures the Wi-Fi Direct network using WPS. Configures the Wi-Fi Direct network with WPS-PBC. Configures the Wi-Fi Direct network using PIN code assigned automatically by the printer. Displays the current PIN code only when WPS Setup is set to PIN Code. Prints the PIN code. Confirm it when entering PIN assigned to the printer into your Wi-Fi mobile device. Resets the PIN code. Ethernet Purpose: To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the printer is turned off and then on again. Values: Auto* 10BASE- T Half 10BASE- T Full 100BASE- TX Half 100BASE- TX Full 1000BASE- T Full TCP/IP Purpose: To configure TCP/IP settings. Values: Detects the Ethernet settings automatically. Uses 10BASE-T Half-duplex. Uses 10BASE-T Full-duplex. Uses 100BASE-TX Half-duplex. Uses 100BASE-TX Full-duplex. Uses 1000BASE-T Full-duplex. IP Mode IPv4 Dual Stack* IPv4 Mode IPv6 Mode Get IP Address IP Address AutoIP* BOOTP RARP DHCP Panel Uses both IPv4 and IPv6 to set the IP address. Uses IPv4 to set the IP address. Uses IPv6 to set the IP address. Sets the IP address automatically. A random value in the range of 169.254.0.0 to 169.254.255.255 that is not currently in use on the network is set as the IP address. The subnet mask is set as 255.255.0.0. Sets the IP address using BOOTP. Sets the IP address using RARP. Sets the IP address using DHCP. Use this option when you want to set the IP address manually on the operator panel. When an IP address is being set manually, the IP is allocated to the printer using the format nnn.nnn.nnn.nnn. Each octet that makes up nnn.nnn.nnn.nnn is a value in the range of 0 to 255. 148 Understanding the Printer Menus