Dell W3007 User Guide - Page 8

Temperature: Operating Nonoperating Humidity: Operating Nonoperating Altitude: Operating Nonoperating Thermal dissipation 5° to 35°C (41° to 95°F) Storage: -20° to 60°C (-4° to 140°F) Shipping: -20° to 60°C(-4° to 140°F) 10% to 80% (noncondensing) Storage: 5% to 90% (noncondensing) Shipping: 5% to 90%(noncondensing) 3,657.6m (12,000 ft) max 12,192 m (40,000 ft) max 501.92 BTU/hour (maximum) 399.5 BTU/hour (typical) Dell Soundbar (Optional) Specifications System Frequency Response 95 Hz to 20 kHz @ 10 dB below avg. SPL Total Power Output Headphone Jack Output Power Input Sensitivity for Rated Output Input Impedance 10 W continuous average power (all speakers operating) @ 10% (THD+N), 1 kHz (FTC rated) 40 mW continuous average power (RL = 32Ω) @ 10% (THD+N), 1 kHz 500 ± 50 mVrms @ 1 kHz >10kΩ Maximum Input Signal Voltage 2 Vrms Controls Input Cables Power On/Off Volume Control 3.0 m ± 0.1 m AWG26 black cable attached to enclosure, with 3.5 mm lime green stereo plug Power Requirements Operating Temperature Range Humidity, Non-condensing DC12V, 1.5A +/-10% 10°C to 40°C 95% RH @ 40 °C Caring for Your Monitor CAUTION: Read and follow the safety instructions before cleaning the monitor. CAUTION: Before cleaning the monitor, unplug the monitor from the electrical outlet. l To clean your antistatic screen, slightly dampen a soft, clean cloth with water. If possible, use a special screen-cleaning tissue or solution suitable for the antistatic coating. Do not use benzene, thinner, ammonia, abrasive cleaners, or compressed air. l Use a slightly-dampened, warm cloth to clean the plastics. Avoid using detergent of any kind as some detergents leave a milky film on the plastics. l If you notice a white powder when you unpack your monitor, wipe it off with a cloth. This white powder occurs during the shipping of the monitor. l Handle your monitor with care as darker-colored plastics may scratch and show white scuff marks more than lighter-colored monitor. l Tohelp maintain the best image quality on your monitor, use a dynamically changing screen saver and power off yourmonitor when not in use. Back to Contents Page