Denon AVR-2112CI AVR2112CI_GettingStarted - Page 9

Basic operation of Setup Wizard Move to the item that you want to configure using ui. Speaker Connection Please select the speaker configuration to be used. 5.1ch 7.1ch Others 5.1ch is the most popular surround system. Speaker Connection Move to the item that you want to configure using o p. 5.1ch is selected for speaker system. Select Yes to confirm. Yes No Enters the selection. Speaker Connection Please connect the speakers. Location :CENTER Terminal :CENTER Press [ENTER] for next connection. Ready to connect Returns to the start of each setting. or Cancels the Setup Wizard. Setup Wizard Do you wish to stop Yes and exit wizard? No You can restart the setup wizard anytime using the on screen menu. SVENSKA NEDERLANDS ESPAÑOL ITALIANO FRANÇAIS DEUTSCH ENGLISH Getting Started 1 3 Insert the main unit power plug into the wall socket. Press AMP to set the remote control unit to AMPoperation mode. Switch the AMP-operation mode To household power outlet (AC 120 V, 60 Hz) Power cord 2 Press ZONE SELECT to switch the zone mode to J (MAIN ZONE). • This remote control is a preset remote control that can be used to control connected devices. 4 Press ON ( Z ) to the this unit. The power switches on, and the Setup Wizard start screen is displayed on the television screen. Power on Switch the zone mode J Lights • This remote control can be operated in two separate zones, MAIN ZONE and ZONE2. • Set the remote control to MAIN ZONE to operate the Setup Wizard. When power is switched to standby Press STANDBY (X). GPower indicator status in standby modeH • Normal standby : Off • When "HDMI Control" (vm page 89) is set to "ON" : Red NOTE During power standby, a minimal amount of power is consumed. To totally cut off the power, remove the power cord from the power outlet. 5 Setup Wizard This wizard assists connection and setup of receiver step by step. You can skip or cancel each section if necessary. Press [ENTER] on remote to start. 1. Language Select 2. Speaker Connection 3. Speaker Calibration 4. Source Setup 5. Remote Setup START 6. Network Setup Complete Press ENTER. Start the Setup Wizard. Setup Wizard has started. Please follow the message on screen. To start the Setup Wizard again after exiting it, select "Setup Wizard" in the menu (vm page 73 "Menu map"). 5 Playback Setup Wizard Preparation