Denon AVR-486S Owners Manual - Page 21
Basic Operation
UPC - 081757506519
View all Denon AVR-486S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Basic Operation Playback INPUT MODE ANALOG MASTER VOLUME EXT. IN INPUT SELECTOR SURROUND MODE SELECT INPUT SELECTOR SURROUND MODE INPUT MODE VOLUME MUTING EXT. IN ANALOG ENGLISH Basic Operation Playback using the external input (EXT. IN) terminals The signals being input to the external decoder input terminals are played without passing through the surround circuitry. Playing the input source Press the EXT. IN button to select the external input. 1 Select the input source to be played. Example: CD (Main unit) (Remote control unit) 2 Select the play (surround) mode. Example: STEREO SELECT (Main unit) (Remote control unit) To select the surround mode while adjusting the surround parameters, tone defeat or tone control, press the SURROUND MODE button and then operate the selector. 3 Start playback on the selected component. For operating instructions, refer to the component's manual. • Cancelling the external input mode: Press the INPUT MODE or ANALOG button to switch to the desired input mode ( page 19, 20). • The external input mode can be set for any input source. To watch video while listening to sound, select the input source to which the video signal is connected, then set this mode. • If the subwoofer output level is too high, set the "SW ATT." surround parameter to "ON". NOTE: • When the input mode is set to the external input (EXT. IN), the play mode (DIRECT, VIRTUAL SURROUND, STEREO, STANDARD (DOLBY/DTS SURROUND), 5CH/7CH STEREO or DSP SIMULATION) cannot be selected. • In play modes other than the external input mode, the signals connected to the EXT. IN terminals cannot be reproduced. In addition, signals cannot be output from channels not connected to the input terminals. Turning the sound off temporarily (MUTING) Use this to turn off the audio output temporarily. Press the MUTING button. 4 Adjust the volume. (Main unit) (Remote control unit) The volume level is displayed on the master volume level display. The volume can be adjusted within the range of -70 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described ( page 29), if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume is adjusted to "18 dB - (Maximum value of channel level)".) • Canceling the MUTING mode: q Press the MUTING button again. w Press the VOLUME button on the remote control unit, or adjust the volume up or down via the front panel MASTER VOLUME knob. 18 ENGLISH