Denon AVR 887 Owners Manual - English - Page 6
Cautions on installation, Before using, About the remote control unit, Inserting the batteries, - avr
View all Denon AVR 887 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ENGLISH Getting Started Getting Started Before using About the remote control unit Operating range of the remote control unit Pay attention to the following before using this unit: • Moving the unit. To prevent short-circuits or damaged wires in the connection cables, always unplug the power supply cord and disconnect the connection cables between all other audio components when moving the unit. • Cautions on using mobile phones. Using a mobile phone near this unit may result in noise. If so, move the mobile phone away from this unit when it is in use. • Before turning the power operation button on. Check once again that all connections are correct and that there are not problems with the connection cables. Always set the power operation button to the standby position before connecting and disconnecting connection cables. • Store the operating instructions in a safe place. After reading the operating instructions, store them in a safe place as they could come in handy in the future. • Whenever the power operation button is in the STANDBY state, the unit is still connected to AC line voltage. Please be sure to turn off the power operation button or unplug the cord when you leave home for, say, a vacation. • Note that the illustrations in these instructions may differ from the actual unit for explanation purposes. Cautions on installation Note: For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure. Note In addition to controlling the AVR-887, the attached remote control unit (RC-1043) can also be used to control the following products: q DENON component products w Component products other than DENON: • Set using the preset memory function ( page 65). Inserting the batteries q Remove the remote control unit's rear cover. w Set two R6P/AA batteries in the battery compartment in the indicated direction. e Put the rear cover back on. Notes on batteries: • Replace the batteries with new ones if the set does not operate even when the remote control unit is operated nearby the unit. (The attached batteries are only for verifying operation.) • When inserting the batteries, be sure to do so in the proper direction, following the "" marks in the battery compartment. • To prevent damage or leakage of battery fluid: • Do not use a new battery together with an old one. • Do not use two different types of batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in flames. • Remove the batteries from the remote if it will not be in use for long periods. • If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. • When replacing the batteries, have the new batteries ready and insert them as quickly as possible. • Point the remote control unit at the remote sensor when operating it. • The remote control unit can be used from a distance of approximately 23 feet/7 meters, at a horizontal angle of up to 30° with respect to the sensor. Approx. 23 feet/7 m 30° 30° NOTE: • It may be difficult to operate the remote control unit if the remote sensor is exposed to direct sunlight or strong artificial light. Wall 3 ENGLISH