Denon AVR 989 Owners Manual - English - Page 22
Multi-zone, External Controller
UPC - 883795000642
View all Denon AVR 989 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications Multi-zone ZONE2 Pre-out Connections • If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 pre-out (variable or fixed level) connectors can be used to play a different program source in ZONE2 the same time (vpage 67 ~ 69). • When using an S-Video cable or a video cable for connection between the AVR-989 and an input device, connect to the video connectors. Monitor (ZONE2) 7*%&0 7*%&0 */ Pre-main amplifier (ZONE2) "6%*0 "6%*0 */ -3 External Controller RS-232C connector This connector is used for an external controller. b If you wish to control the AVR-989 from an external controller using the RS-232C connector, perform the operation below beforehand. q Turn on the AVR-989's power. w Turn off the AVR-989's power from the external controller. e Check that the AVR-989 is in the standby mode. LR • When using in combination with an RF Remote Trigger output jack Controller (RC-7000CI, sold separately) or RF Remote Receiver (RC-7001RCI, sold separately) The power of an external device equipped with two-way communication with an RF Remote LR a trigger input jack can be turned on and off in Controller is possible. association with operations on the AVR-989. For The AVR-989's status information as well as details, see menu "Manual Setup" - "Option iPod can be browsed watching the RF Remote Setup" - "Trigger Out" (vpage 34). Controller's display. For details, refer to the • Output: DC 12 V 150 mA MAX. operating instructions of the respective devices. Check the trigger input conditions of the • When used in combination with an RF Remote connected device. Controller or RF Remote Receiver, make the settings at menu "Manual Setup" - "Option Setup" - "232C Port" - "2Way Remote" (vpage 34). • On the menu, when setting "Manual Setup" - "Option Setup" - "232C Port" to "2Way Remote", you cannot use the RS-232C connector as an external controller (vpage 34). "69 065 Infrared retransmitter Input Output Infrared sensor Extension jack for future use. (Connect devices corresponding with room to room function to this jack.) NOTE • For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced. • For instructions on installing and operating separately sold devices, refer to the respective devices' operating instructions. • To conduct multi-zone playback, see "Amp Assign / Multi-zone Connections and Operations" (vpage 65, 66). 19