Denon AVR2310CI Owners Manual - Page 22
Connecting the Power Cord - avr 2310ci a v receiver
UPC - 837654710111
View all Denon AVR2310CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications ENGLISH External Controller n RS-232C connector When you connect an external control device, you can control the AVR-2310CI with the external control device. Perform the operation below beforehand. q Turn on the AVR-2310CI's power. w Turn off the AVR-2310CI's power from the external controller. e Check that the AVR-2310CI is in the standby mode. n REMOTE CONTROL jacks Infrared retransmitter "69 065 Input Infrared sensor Output Extension jack for future use. (Connect devices corresponding with room to room function to this jack.) Connecting Devices not Equipped with HDMI terminals Connecting the Power Cord Wait until all connections have been completed before connecting the power cord. Power cord To household power outlet (AC 120 V, 60 Hz) Set as Necessary Set this to use the RS-232C connector for the DENON RF remote controller. "232C Port" (vpage 35) When using the AVR-2310CI in combination with the DENON RF remote controller (RC-7000CI, sold separately) or RF remote receiver (RC-7001RCI, sold separately), two-way communication is enabled. The AVR-2310CI's status information as well as iPod and Internet audio music files can be browsed watching the RF Remote Controller's display. For details, refer to the operating instructions of the respective devices. NOTE On the GUI menu, when setting "232C Port" to "2Way Remote", you cannot use the RS-232C connector as an external controller (vpage 35). 19 n TRIGGER OUT jacks The TRIGGER OUT output terminal outputs a maximum 12 V/150 mA electrical signal. When a device with TRIGGER IN terminal is connected via a monaural mini-plug, the connected device's power on/standby can be controlled through linked operation to the AVR-2310CI. Set as Necessary Set to change the conditions for linked operation via the TRIGGER OUT terminal. "Trigger Out" (vpage 35) Connection to the AC outlets • These outlets supply power to external au- dio equipment. • Audio equipment with a total power con- sumption of 120 W (1 A) can be connect- ed. • The power supply turns on and off together with the on the main unit. When set to "ON", power is supplied from the outlet. When set to "STANDBY", no power is sup- plied. NOTE When "HDMI Control" (vpage 31) is set to "ON", power is supplied constantly to the AC outlet (UNSWITCHED). NOTE • Insert the AC plugs securely. Incomplete connections could cause noise. • Only use the AC outlets to plug in audio equipment. Do not use them as power supplies for hairdryers or anything other than audio equipment.