Denon DHT FS3 Owners Manual - English - Page 15

ENGLISH Getting Started Installation Connections Settings Operation Other functions Detailed Settings 1 At [SETUP], select the first menu. 2 Press [ENTER]. • The second menu is displayed. 3 Use [ui] to select, then press [ENTER]. b Set the third menu in the same way. • Select the different items on the menus while they are displayed (within 5 seconds). • The settings remain in effect even after the power has been turned off. • Settings indicated by are the factory defaults. 1st menu Use to select, to set. TONE Tone adjustment (bass/treble) 2nd menu Use to select, to set. BASS Bass level Set TREBLE Treble level Set FADER Set Front/rear volume balance adjustment NIGHT Set Night mode setting OFF MOVIE MUSIC Normal balance For movie sources For music sources OFF ON Normal playback Night mode on ROOM Settings for the installation position and wall hardness Set (how the sound reflects) DIST OFFSET REFL Distance to listening position Offset from center Set How sound reflects off walls GAIN Adjustment of the input level for the Set different analog input functions DELAY Set Adjustment of the audio delay time TV AUX b Sound connected to TV input terminals b Sound connected to AUX input terminals Set Adjustment range: 0 ms ~ 170 ms 3rd menu Use to select, to set. Adjustment range: -12 dB ~ 0 dB ~ +12 dB • The surround level is higher for the MOVIE mode than for the MUSIC mode. • Set this to "ON" when listening with the volume low (for example at night) to make the dialogs more distinct. • Valid for "DOLBY" and "DTS" digital audio input sources. Distance adjustment range: 3.9 ft / 1.2 m ~ 8.9 ft / 2.7 m ~ 17.7 ft / 5.4 m Offset distance adjustment range: 2.9 ft / 0.9 m to 9.8 ft / 3.0 m for both L and R. This depends on the setting of the distance to the listening position ("DIST"). Reflection setting items: SOFT ... ...When there are curtains, etc. MEDIUM ... ...For wood or other soft walls HARD ... ...For glass or hard walls, etc. Adjustment range: 0 dB or +6 dB PWR ON Auto power mode setting DUAL Bilingual audio setting CENTER Speaker mode setting ON Auto power on Set OFF Low standby power mode MAIN Main audio played Set SUB Sub audio played M/S Both main and sub audio played OFF Normal playback Set ON DHT-FS3's surround function off 11 ENGLISH • Turns on when an audio input is detected. Turns off if no signal is input for over 10 minutes. b Depending on the connected device, the auto power mode may not work. If this happens, turn the DHT-FS3's power on and off manually. • Turn this on when connecting an AV amplifier and using for the center speaker and subwoofer. The DHT-FS3's surround-related functions are turned off. Operating the remote control unit Troubleshooting Specifications