Denon DN-X1100 Owners Manual - Page 7

Q5 CROSSFADER CONTOUR control Allows adjusting the "shape" of the Crossfader response from a gentle curve for smooth, long running fades, to the steep pitch required for top performance cut and scratch effects. Q6 CH FADER CONTOUR control Adjusts the volume curve response of the channel fader. Q7 CH FADER START switch This function will start the performance of CD player with Ch. Fader automatically is on/off. FADER START If the separately sold DN-S1200, DN-S3500, DN-HS5500 and etc. players are connected to LINE2, 4, 6 or 8, they can be started using the source input fader (Ch. Fader) or Crossfader, as long as the 3.5 mm stereo mini cords have been connected. Q8 MASTER BALANCE control Adjusts the L/R balance of the MASTER output. Q9 EFFECTS ON/OFF button • Routes the assigned signal through the external processor attached to the SEND/RETURN connectors on the rear. • When the EFFECT is ON, the button is lit. • The effect button is flashing when there is no connection of the effects. W0 EFFECTS WET/DRY control Use this to adjust the ratio of original and effected sound. W1 PRE/POST switch (EFFECTS) Use this to select pre-fader or post-fader. W2 EFFECTS ASSIGN switch Use this to select the source of the external processor. W3 CUE buttons Pressing in any or all of CUE buttons routes the respective source to the headphone and meter cue sections. Pressing multiple buttons makes it possible to derive mixed sound from the selected sources. W4 BOOTH LEVEL control Adjusts the level of the BOOTH outputs. W5 BOOTH ASSIGN switch Selects the source of the BOOTH output. W6 POWER switch Press the switch to turn the power on. W7 Peak dB CUE/PROGRAM meter • Displays the output level following Master Level adjustment, the peak level is held for 1 second. Display range: -24 dB to +12 dB. • Can switch between two display modes. See below u, i. W8 MASTER LEVEL control Adjusts the level of the MASTER outputs. W9 POWER indicator When the red indicator is lit, the DN-X1100 is ready to go. E0 Source EQ controls Use VRs with center detent for equaliser. HI Adjusts the high-tone sound -33 dB to +10 dB. At the center position, sound is flat. MID Adjusts the mid-tone sound -35 dB to +10 dB. At the center position, sound is flat. LOW Adjusts the low-tone sound -35 dB to +6 dB. At the center position, sound is flat. E1 LEVEL controls Adjusts the level of the selected input - ∞ to +15 dB. E2 SOURCE INPUT SELECT switches (Input selectors) • Select any source from eight inputs (PHONO1/ LINE1, LINE2, PHONO2/LINE3, LINE4, PHONO3/ LINE5, LINE6, LINE7, LINE8) for each channel independently. • Y ou also can assign the same input to several channels for creative mixing. E3 CH LEVEL meter Display range: -24 dB to +12 dB. Displays the input level after adjusted with LEVEL E1 and Source EQ E0 controls. ENGLISH  Getting Started Connections Fader Start Specifications