Denon DRA 685 Owners Manual - Page 6

ENGLISH 5 CONNECTIONS • Do not plug in the power cord until all connections have been completed. • Be sure to connect the left and right channels properly (left with left, right with right). • Insert the plugs securely. Incomplete connections will result in the generation of noise. • Use the AC OUTLETS for audio equipment only. Do not use them for hair driers, etc. • Note that binding pin plug cords together with power cords or placing them near a power transformer will result in generating hum or other noise. • If hum or other noise is produced when the ground wire is connected, disconnect it. • Noise or humming may be generated if a connected component is used independently without turning the power of this unit on. If this happens, turn on the power of the this unit. Connecting the audio components Turntable (MM cartridge) NOTE: This unit cannot be used with MC cartridges directly. Use a separate head amplifier or stepup transformer. Ground wire LINE OUT OUTPUT RL CD player RL DIGITAL AUDIO Connecting a CD player Connect the CD player's analog output jacks (ANALOG OUTPUT) to this unit's CD jacks using pin plug cords. PRE OUT jacks MAIN IN jacks Use these jacks when using another separate amplifier or a pre-main amplifier. AC CORD AC 120 V, 60 Hz LINE OUT RL PHONO SIGNAL R GND LOOP ANT. AM FM COAX. 75 L ANTENNAR OUT MULTI SOURCE R L R R L AUDIO R L IN CD DLVD / R VDP V.AUX VCR VIDEO OUT MONITOR DVD / VDP V.AUX IN VCR TAPE VCR TAPE L OUT L MULTI SOURCE OUT VCR IN ROOM TO ROOM (REMOTE CONTROL) AUDIO R L PRE OUT MAIN IN SPEAKER SYSTEMS AC OUTLETS RBL + RAL SWITCHED TOTAL 120W(1A.) MAX. 120V 60Hz + - - IMPEDANCE A or B : 4 16 A + B : 8 16 LINE IN Tape deck R LR L LINE IN AUX OUT Sub room RC-617 (Sold Separately) Infrared sensor + RC-616 (Sold Separately) Infrared retransmitter + R LR L OUTPUT INPUT Connecting a tape deck Connections for recording: Connect the tape deck's recording input jacks (LINE IN or REC) to this unit's tape recording (OUT) jacks using pin plug cords. Connections for playback: Connect the tape deck's playback output jacks (LINE OUT or PB) to this unit's tape playback (IN) jacks using pin plug cords. OUTPUT INPUT Power amplifier Connecting the AC OUTLETS AC OUTLETS • SWITCHED (total capacity - 120 W (1 A.) The power to this outlet is turned on and off in conjunction with the POWER operation switch on the main unit, and when the power is switched between on and standby from the remote control unit. No power is supplied from these outlets when this unit's power is at standby. Never connect equipment whose total capacity is above 120 W (1 A.) NOTE: Use the AC OUTLETS for audio equipment only. Do not use them for hair driers, etc. 6