Dewalt DCD985M2 User Guide - Page 12
Battery Pack from the Tool
View all Dewalt DCD985M2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ENGLISH j. Battery release button k. Belt hook l. Mounting screw m. Bit clip INTENDED USE These drills drivers/hammerdrills are designed for professional drilling, percussion drilling and screwdriving applications. DO NOT use under wet conditions or in presence of flammable liquids or gases. These drills/drivers/hammerdrills are professional power tools. DO NOT let children come into contact with the tool. Supervision is required when inexperienced operators use this tool. • This product is not intended for use by persons (including children) suffering from diminished physical, sensory or mental abilities; lack of experience, knowledge or skills unless they are supervised by a person responsible for their safety. Children should never be left alone with this product. Electrical Safety The electric motor has been designed for one voltage only. Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Your DeWALT charger is double insulated in accordance with EN 60335; therefore no earth wire is required. If the supply cord is damaged, it must be replaced by a specially prepared cord available through the DeWALT service organization. WARNING: No connection is to be made to the earth terminal. Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 3 A. Using an Extension Cable An extension cord should not be used unless absolutely necessary. Use an approved extension cable suitable for the power input of your charger (see Technical Data). The minimum conductor size is 1 mm2; the maximum length is 30 m. When using a cable reel, always unwind the cable completely. ASSEMBLY AND ADJUSTMENTS WARNING: Prior to assembly and adjustment, always remove the battery pack. Always switch off the tool before inserting or removing the battery pack. WARNING: Use only DeWALT battery packs and chargers. Inserting and Removing the Battery Pack from the Tool (Figure 2) NOTE: For best results, make sure your battery pack is fully charged. TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE 1. Align the battery pack (i) with the rails inside the tool's handle (Figure 2). 2. Slide it into the handle until the battery pack is firmly seated in the tool and ensure that it does not disengage. TO REMOVE THE BATTERY PACK FROM THE TOOL 1. Press the battery release button (j) and firmly pull the battery pack out of the tool handle. 2. Insert battery pack into the charger as described in the charger section of this manual. Variable Speed Switch (Figure 1) To turn the tool on, squeeze the trigger switch (a). To turn the tool off, release the trigger switch. Your tool is equipped with a brake. The chuck will stop as soon as the trigger switch is fully released. NOTE: Continuous use in variable speed range is not recommended. It may damage the switch and should be avoided. Side Handle (Figure 1) WARNING:To reduce the risk of personal injury, ALWAYS operate the tool with the side handle properly installed. Failure to do so may result in the side handle slipping during tool operation and subsequent loss of control. Hold tool with both hands to maximize control. The side handle (h) clamps to the front of the gear case and may be rotated 360˚ to permit right- or left-hand use. Side handle must be tightened sufficiently to resist the twisting action of the tool if the accessory binds or stalls. Be sure to grip the side handle at the far end to control the tool during a stall. 10