Dewalt DWFP12233 Instruction Manual - Page 10
Tool Operation Check Fig.1, Loading the Tool Fig. 1, 4
View all Dewalt DWFP12233 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
English Rotate the trigger mode selector (B) FIG. 3 counterclockwise to the contact action position , as shown in Figure 3. To operate the tool using the PLACE ACTUATION method: WARNING: A fastener will fire each time the trigger is depressed as long as the contact trip remains depressed. 1. Depress the contact trip against the work surface. 2. Depress the trigger. To operate the tool using the BUMP ACTUATION method: 1. Depress the trigger. 2. Push the contact trip against the work surface. As long as the trigger is depressed, the tool will fire a fastener every time the contact trip is depressed. This allows the user to drive multiple fasteners in sequence. WARNING: Do not keep trigger depressed when tool is not in use. Keep the contact trip lock-off engaged in the locked position when the tool is not in use. Tool Operation Check (Fig.1) WARNING: If the tool is dropped or you suspect tool damage perform tool operation check. WARNING: Remove all fasteners from tool before performing tool operation check. SEQUENTIAL TRIP ACTION A. Press the contact trip against the work surface, without touching the trigger. THE TOOL MUST NOT CYCLE. B. Hold the tool off the work surface and pull the trigger. THE TOOL MUST NOT CYCLE. C. Pull the trigger and press the contact trip against the work surface. THE TOOL MUST NOT CYCLE. D. With finger off the trigger, press the contact trip against the work surface. Pull the trigger. THE TOOL MUST CYCLE. CONTACT TRIP ACTION A. With finger off the trigger, press the contact trip against the work surface. THE TOOL MUST NOT CYCLE. B. Hold the tool off the work surface, and pull the trigger. THE TOOL MUST NOT CYCLE. C. With the tool off the work surface, pull the trigger. Press the contact trip against the work surface. THE TOOL MUST CYCLE. D. Without touching the trigger, press the contact trip against the work surface, then pull the trigger. THE TOOL MUST CYCLE. Loading the Tool (Fig. 1, 4) WARNING: Disconnect air line from tool and remove fasteners from magazine before making adjustments or personal injury may result. WARNING: Keep tool pointed in a safe direction when loading fasteners or personal injury may result. 1. Depress magazine release (G) and pull magazine (F) back. 8