Dewalt DWX723 Instruction Manual - Page 5
DW7231 D, WALT Miter Saw Mounting, Method Fig. 6, 7 - accessories
View all Dewalt DWX723 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
English Pull the extendable extension arm out to the desired length. Turn the extension arm lock lever clockwise to lock. DW7231 DEWALT Miter Saw Mounting Method (Fig. 6, 7) WARNING: To reduce the risk of injury, turn unit off, disconnect machine from power source before assembling the miter saw to the miter saw stand. An accidental start-up can cause injury. WARNING: Stability Hazard. You must use the Universal Miter Saw Mounting Method when mounting a miter saw not manufactured by DEWALT to this miter saw stand. WARNING: To reduce the risk of personal injury, be sure the miter saw is fully anchored on the stand. WARNING: For your own safety, read and understand the miter saw instruction manual before using. Failure to heed these warnings may result in personal injury and serious damage to the miter saw and the accessory. 1. Place saw in operational position with blade facing you. Align with label on the mounting bracket showing front. 2. Place a spacer, such as a 2 x 4, under one side of the miter saw to hold the saw's mounting feet above the work surface. 3. Hold a mounting bracket under the saw and feed a carriage bolt (hardware bag) up through the bracket and the foot of the saw. NOTE: See DW7231 Hardware Selection Chart for the correct mounting hardware procedures for DEWALT miter saws. Follow all instructions properly, otherwise the miter saw's table rotation may be obstructed. DW7231 HARDWARE SELECTION CHART Left Side Right Side DW703 1 1 DW705 1 1 DW706 1 1 DW708 1 2 DW712 1 2 DW713 1 1 DW715 1 1 DW716 1 1 DW717 2 1 DW718 3 2 1 = Long screw, Head on bottom 2 = Short screw, Head on bottom 3 = Long screw, Head on top 4. Once the carriage bolt (hardware bag) is installed per DW7231 Hardware Selection Chart, assemble a flat washer, lock washer and nut onto the bolt. Tighten the bolts finger tight. 3