Dymo LabelWriter SE450 Label Printer Quick Start Guide - Page 5
Installing as a Serial ASCII Printer Windows
View all Dymo LabelWriter SE450 Label Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installing as a Serial ASCII Printer (Windows) 1 Plug the end of the serial cable with the RJ11 connector into the serial port on the bottom of the printer. See Figure 3. 10101 24VDC USB 10101 24VDC 2 Connect the 9-pin serial connector to an available serial port on your computer or device, as appropriate. 3 Plug the power cord into the power adapter. 4 Plug the power adapter into the power connector on the bottom of the printer. 5 Insert the cables through the cable channel. 6 When all the cables are connected, plug the power cord into an electrical outlet. Figure 3 7 Configure the printer port with the appropriate settings. The printer default settings are: Baud Rate: 9600 Data Bits: 8 Stop Bits: 1 Parity: None Follow the instructions in "Loading Labels" on page 6 to correctly load labels onto the spool and insert the spool into the printer. 3