Electrolux E24RD75HPS Wiring Diagram - Page 1
Electrolux E24RD75HPS - 24" Double Drawer Refrigerator Manual
View all Electrolux E24RD75HPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS AT MID-POINT CONTROL SETTING Type A with Run/Start Capacitor 65°F (18°C) Ambient 90°F (32°C) Ambient Operating Time N/A 30 to 50% Temperature 34º F to 45º F 34º F to 45º F Low Side Pressure (cut-in) 30 to 45 psig 208 to 310 kPa 30 to 45 psig 208 to 310 kPa Low Side Pressure (cut-out) -2 to 4 psig -14 to 28 kPa -2 to 4 psig -14 to 28 kPa High Side Pressure (last 1/3 cycle) 90 to 120 psig 621 to 827 kPa 130 to 175 psig 896 to 1207 kPa Wattage (last 1/3 cycle) 85 to 125 85 to 125 Amps (running) .75 to 1.2 .75 to 1.2 Base Voltage 115 vac (127 vac max) CONDENSER FAN MOTOR Watts RPM Amps 3.1 1100 CW Opposite Shaft 0.03 Running EVAPORATOR FAN MOTOR 1.7 each 9000 .02 each service data sheet 242007200 REFRIGERATOR DRAWERS - R134a Model Designer Professional important safety NOTE The information provided herein is designed to assist qualified repair personnel only. Untrained persons should not attempt to make repairs due to the possibility of electrical shock. Disconnect power cord before servicing this appliance. IMPORTANT If any green grounding wires are removed during servicing, they must be returned to their original position and properly secured. Caution All electrical parts and wiring must be shielded from torch flame. DO NOT allow torch to touch insulation; it will char at 200°F and flash ignite (burn) at 500°F. Excessive heat will distort the plastic liner. NOTE Your Electrolux refrigerator drawers has been designed for builtin installation. Your refrigerator drawers do not require additional air space for top, sides or rear. The front grille must NOT be obstructed. To ease unit installation and removal, it is recommended that the cabinet rough opening dimensions be increased by at least ¼ inch over the dimensions given for your unit. IMPORTANT: PLEASE RETURN THIS SHEET TO IT'S ORIGINAL LOCATION. WARNING Double drawer Refrigerator Drawers are designed to be builtin only. They can not be used for free-standing. All screws supplied with the Anti-Tip Kit are for mounting the bracket directly to wall studs. These screws will not work if used with sheetrock (dry wall) or anything other than wall studs. ICONTM Unit Dimensions Width Height 2313/16 inch 34-35 inches 2313/16 inch 34-35 inches Depth 263/4 inch 263/4 inch ICONTM Designer 2.75" ICONTM Professional 2.75" 3.25"