Electrolux E24WC75HPS Wiring Diagram - Page 1

PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS AT MID-POINT CONTROL SETTING Type A with Run/Start Capacitor 65°F (18°C) Ambient 90°F (32°C) Ambient Operating Time N/A 14 to 37% Wine Cooler Temperature 45º F to 65º F 45º F to 65º F Low Side Pressure (cut-in) 30 to 45 psig 208 to 310 kPa 30 to 45 psig 208 to 310 kPa Low Side Pressure (cut-out) -2 to 4 psig -14 to 28 kPa -2 to 4 psig -14 to 28 kPa High Side Pressure (last 1/3 cycle) 90 to 120 psig 621 to 827 kPa 130 to 175 psig 896 to 1207 kPa Wattage (last 1/3 cycle) 85 to 125 85 to 125 Amps (running) .75 to 1.2 .75 to 1.2 Base Voltage 115 vac (127 vac max) CONDENSER FAN MOTOR Watts RPM Amps 3.1 1100 CW Opposite Shaft 0.03 Running WINE COOLER EVAPORATOR FAN MOTOR 1.7 each 9000 .02 each service data sheet 241957100 WINE COOLER - R134a Caution All electrical parts and wiring must be shielded from torch flame. DO NOT allow torch to touch insulation; it will char at 200°F and flash ignite (burn) at 500°F. Excessive heat will distort the plastic liner. NOTE Your Electrolux wine cooler has been designed for either freestanding or built-in installation. When built-in, your wine cooler does not require additional air space for top, sides or rear. In either case, the front grille must NOT be obstructed. To ease unit installation and removal, it is recommended that the cabinet rough opening dimensions be increased by at least ¼ inch over the dimensions given for your unit. All units require zero clearance when installed flush with a cabinet or wall. Electrolux stainless steel models require a minimum 2-11/16" (PRO) or 2-1/16" (DESIGNER) handle clearance when installed against a wall or cabinet that extends beyond the front edge of the unit. Unit Dimensions - ICON DESIGNER Unit Dimensions - ICON PRO important safety NOTE The information provided herein is designed to assist qualified repair personnel only. Untrained persons should not attempt to make repairs due to the possibility of electrical shock. Disconnect power cord before servicing this appliance. IMPORTANT If any green grounding wires are removed during servicing, they must be returned to their original position and properly secured. IMPORTANT: PLEASE RETURN THIS SHEET TO IT'S ORIGINAL LOCATION.