Electrolux E30EW85GSS Owners Guide - Page 8
Oven Rack Supports & Oven Vents
UPC - 057112096346
View all Electrolux E30EW85GSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
8 Feature Overview OVEN RACK SUPPORTS & OVEN VENTS Oven Vent Location The oven is vented under upper control panel for the upper oven and between the doors for the lower oven. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. Oven Vent Warm Air Installing Oven Rack Supports ALWAYS INSTALL OVEN RACK SUPPORT BEFORE TURNING ON THE OVEN (WHEN THE OVEN IS COOL). To install oven rack support, insert the supports by pushing them downward into the two brackets on each side of the oven interior, as shown below. To remove the oven rack support for a self-clean cycle, pull up the support to disengage them from the brackets. If the rack supports are not removed, the self-clean cycle won't start. Removing and Replacing Extendable Oven Racks ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven. To remove an oven rack, pull the rack forward. Lift up the rack off the oven rack slider. To install an oven rack, locate the two pinholes in the small plates at the front corners of the rack. Place the rack on the side sliders and drop the pin holes over the pins on the sliders. Installed on sliders Oven Vent Warm Air To remove from sliders To place on sliders Pull oven rack forward and lift it up off the oven rack slider. Do not try to install the extendable oven racks into the standard oven rack levels (or rack support). Installing Standard Oven Rack ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven. To install, take standard oven rack with the handle in front of you and the stoppers looking down. Align the rear of the rack on the level you want to install it, then push on the rack to slide it in the level until it stops. Must point upward BACK FRONT This stopper will prevent the rack to bump on the convection fan cover at the end of its course. This "safety stopper" will stop the rack when you pull it out. This will prevent you to accidentally pull the rack too far and make it fall. Do not try to install the standard oven rack on the sliders.