Electrolux E32AF75FPS Owners Guide - Page 7

Installation 7 This Owner's Guide provides specific operating instructions for your model. Use the freezer only as instructed in this Owner's Guide. Before starting the freezer, follow these important first steps. INSTALLATION • Choose a place that is near a grounded electrical outlet. DO NOT use an extension cord or an adapter plug. • For most efficient operation, the freezer should be 1" (25mm) located where surrounding temperatures will not drop below 40ºF (5ºC) or exceed 110ºF (43ºC). • Allow the following clearances for ease of installation, proper air circulation, and electrical connections: Sides 3/8 inch 1" (25mm) Back & Top 1 inch • Do not block the toe grille on the lower front of your freezer. Sufficient air circulation is essential for the proper operation of your freezer. 3/8" (10mm) Refrigerator Freezer NOTE The exterior walls of the freezer may become quite warm as the compressor works to transfer heat from the inside. Temperatures as much as 30ºF warmer than room temperature can be expected. Door Opening NOTE If your freezer is placed with the door hinge side against a wall, you may have to allow additional space so the door can be opened wider. Leveling The freezer must have all bottom corners resting firmly on a solid floor. The floor must be strong enough to support a fully loaded freezer. It is VERY IMPORTANT for your freezer to be level in order to function properly. If the freezer is not leveled during installation, the door may be misaligned and not close or seal properly, causing cooling, frost or moisture problems.