Electrolux E32AF75JPS Owners Guide - Page 13

Theater™ Lighting and Water Supply 13 Theater™ LED Lighting The interior cabinet lighting features LED lights that gradually ramp up in intensity after the door is opened. Unplug the unit or switch the breaker that supplies power to the unit to the off position before changing an LED light. To replace an LED: 1. Unplug the electrical cord or switch OFF the power supply breaker. 2. Push down on the LED cover and then pull away from the cabinet interior. 3. From the inside of the LED cover, remove the wire harness connector by pressing on the latch with a small flat bladed screwdriver. Pull the wire harness connector out of the LED. 4. Replace with a new LED and install in the reverse order. Water Supply To avoid electric shock, which can cause death or severe personal injury, disconnect the freezer from electrical power before connecting a water supply line to the freezer. To Avoid Property Damage: • Copper or Stainless Steel braided tubing is recommended for the water supply line. Water supply tubing made of ¼ inch plastic is not recommended to be used. Plastic tubing greatly increases the potential for water leaks, and the manufacturer will not be responsible for any damage if plastic tubing is used for the supply line. • DO NOT install water supply tubing in areas where temperatures fall below freezing. • Chemicals from a malfunctioning softener can damage the ice maker. If the ice maker is connected to soft water, ensure that the softener is maintained and working properly. Ensure that your water supply line connections comply with all local plumbing codes. Push on Underside of Connector to Release Latch Remove Wire Harness Connection Before Installing The Water Supply Line, You Will Need: • Basic Tools: adjustable wrench, flat-blade screwdriver, and PhillipsTM screwdriver • Access to a household cold water line with water pressure between 30 and 100 psi. • A water supply line made of ¼ inch (6.4 mm) OD, copper or stainless steel tubing. To determine the length of tubing needed, measure the distance from the ice maker inlet valve at the back of the freezer to your cold water pipe. Then add approximately 7 feet (2.1 meters), so the freezer can be moved out for cleaning (as shown). • A shutoff valve to connect the water supply line to your household water system. DO NOT use a self-piercing type shutoff valve. • A compression nut and ferrule (sleeve) for connecting a copper water supply line to the ice maker inlet valve.