Electrolux E36DF76EPS Installation Instructions - Page 7
Preparing for Installation - model
View all Electrolux E36DF76EPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Preparing for Installation 7 VERIFY PACKAGE CONTENTS • Use & Care Manual • Broiler Pan/Insert • Anti-tip Bracket • Grate Pack • Griddle • LP Conversion Kit • Burner Rings • Wok Ring • Simmerplate • Stainless Steel Cleaner • Roasting Rack • Burner Cap Pack GAS SUPPLY REQUIREMENTS Check your local building codes for the proper method of installation. In the absence of local codes, this appliance should be installed in accordance with the National Fuel Gas Code ANSI Z223.1. Be certain that the appliance being installed is correct for the gas service being provided. Refer to the rating label located on the kick panel and/or the table below for gas supply requirements. GAS AND ELECTRIC REQUIREMENTS TABLE Refer to the following table for more information on gas and electric requirements. NOTE This range is shipped from the factory pre-set for use with natural gas. For LP conversion see the accompanying LP Conversion Kit. The electrical information in the table is also located on the serial number label on the range. It can be found by opening the oven door and looking through the inlet air cooling grill. Model No. Electrical Total circuit connected required load Gas type Manifold pressure Minimum gas supply pressure E30DF74EPS 240-4 Wire VAC, 60Hz, 30A 26.4 Amps (6.3 Kw) Natural 4" Water Column 5" Water Column Liquid Propane 10" Water Column 11" Water Column 240-4 26.4 Amps Natural 4" Water Column 5" Water Column E36DF76EPS Wire VAC, (6.3 Kw) 60Hz, 30A Liquid Propane 10" Water Column 11" Water Column 240-4 E48DF76EPS Wire VAC, 44.2 Amps Natural 4" Water Column 5" Water Column 60Hz, 50A (10.4 Kw) Liquid Propane 10" Water Column 11" Water Column