Electrolux EFLS527UIW Complete Owners Guide English - Page 14
Connecting the drain, Completing the installation, Electrical System Requirements - reviews
View all Electrolux EFLS527UIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 Installation 6. Tighten by hand until snug. Then tighten each supply connection another 2/3 turn with pliers. Do not bend, kink or pinch water inlet hoses. 7. Turn on the water and check for leaks. NOTE The standpipe inside diameter must be 1-1/4" (3.2 cm) minimum. There must be an air gap around the drain hose in the standpipe. A snug hose fit can cause a siphoning action. Completing the installation Connecting the drain 1. Verify the antisiphon disc is in place. Anti-Siphon Disc 2. Form a "U" shape on the end of the drain hose with the hose pointed toward the drain. Place the formed end in a laundry tub or a standpipe and secure the drain hose with the cable tie (provided in the enclosure package) to the standpipe, inlet hose, laundry tub, etc. so the hose does not pull out from the force of the water. Insert Less Than 8.5" (21.5 cm) Cable Tie 1. Plug the power cord into a grounded outlet. WARNING ELECTRICAL SHOCK HAZARD Improper connection of the equipment grounding conductor can cause an electrical shock that may result in serious injury or death. Check with a licensed electrician if you are in doubt as to whether the appliance is properly grounded. See Electrical System Requirements and Grounding Requirements sections of this instruction for additional information. 2. Turn on the power at a circuit breaker/ fuse box. 3. Carefully slide the washer to its final position. Recheck for level and rock corners for stability. See Leveling the washer. Remove and discard door tape. 4. Run the washer through a complete cycle, checking for water leaks and proper operation. 5. If you have any questions during initial operation, please review the "Troubleshooting" section before calling for service. 6. Place these instructions in a location near the washer for future reference. IMPORTANT Check to ensure the power is off at a circuit breaker/fuse box before plugging the power cord into an outlet. NOTE A wiring diagram and technical data sheet are located under the washer top panel, on top of the detergent dispenser housing.