Electrolux EFLS627UIW Complete Owners Guide English - Page 35
Installation, Instructions, OCCURRENCE, POSSIBLE CAUSE, SOLUTION
View all Electrolux EFLS627UIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Before Calling 35 OCCURRENCE POSSIBLE CAUSE SOLUTION Warm or hot wa- • Hot water heater is set too • Measure hot water temperature at ter is not hot low or is a distance from nearby faucet with candy or meat enough washer. thermometer. Water temperature should be at least 120°F (49°C). Adjust water heater as necessary. • Hot water is being used • Avoid using hot water elsewhere elsewhere in the house. before or during washer use. There may not be enough hot water avail- able for proper cleaning. If problem persists, your hot water system may be unable to support more than 1 use at a time. Water in washer • Drain hose is kinked or • Clean and straighten the drain does not drain or clogged. hose. drains slowly • Drain hose standpipe is too • Reduce standpipe height to less tall. Maximum standpipe than 8' (2.4 m). See Installation height is 8' (2.4 m). Instructions. • House drain pipes are • Unclog drain pipes. Contact clogged. plumber if necessary. Water leaks • Fill hose connection is loose • Check and tighten hose connec- at faucet or washer. tions. Install rubber sealing washers provided. • Dispenser drawer not com- • Close dispenser drawer completely. pletely closed • Water hoses have damage, • Replace hoses. cuts or corrosion. Oversudsing • HE detergent is not being • Run rinse cycle. Use a low-sudsing, used. high efficiency detergent. • Run rinse cycle. Use less detergent • Too much detergent. in future loads. Incorrect wash • Hot and cold water hoses • Connect hot water hose to hot and rinse tem- are connected to wrong water faucet and cold water hose peratures. The supply faucets. to cold water faucet. LED display will alert this condi- tion with "HOSE" alarm Water is entering • Drain hose standpipe is too • Increase standpipe height to at washer but tub low. Standpipe must be a least 23.6" (60 cm). See Installation does not fill min of 23.6" (60 cm) high to Instructions. prevent siphoning.