Epson 1810p Product Information Guide - Page 25

PowerLite 1810p/1815p Replacing the Lamp and Air Filter The life span of the projection lamp is about 2,500 hours if Brightness Control in the Settings menu is set to High (default), and 3,000 hours if Brightness Control is set to Low. It is time to replace the lamp when: ❏ The projected image gets darker or starts to deteriorate. ❏ The message Replace the lamp appears on the screen when the lamp comes on and the lamp warning light flashes orange. To maintain projector brightness and image quality, replace the lamp as soon as possible. ❏ The lamp warning light out). flashes red (the lamp is burnt 4. Loosen the two screws holding the lamp in place (you can't remove them). Loosen, but don't remove these screws Lamp warning light 5. Hold the lamp as shown and pull it straight out. Follow these steps to replace the lamp and air filter: 1. Turn off the projector and unplug the power cord. 2. Let the projector cool for at least an hour (if it has been on). The lamp is extremely hot immediately after use. 3. Loosen the lamp cover screw (you don't need to remove it). Then slide the lamp cover to the side and lift it off the projector. 6. Gently insert the new lamp. (If it doesn't fit easily, make sure it is facing the right way.) 7. Once the lamp is fully inserted, tighten its screws. 8. Replace the lamp cover, then tighten its screw. 9. Slide out the air filter on the bottom of the projector and remove it. 10.Slide in the new air filter until it clicks in place. 11.Reset the lamp timer as described in the next section. Note: When you get a replacement lamp for your projector, you should replace the filter. Turn off this product when not in use to prolong the life of the projector. 3/08 PowerLite 1810p/1815p - 25