Epson 1925W Network and PC Free Operation Guide - Page 41

Connecting to a Projector on a Different Subnet 41 Connecting to a Projector on a Different Subnet By default, this application only searches for projectors on the same subnet as the computer. Therefore, even if you perform a search for projectors on the network, projectors on a different subnet will not be found. You can, however, identify and connect to a projector on a different subnet as follows: • Specify either an IP address or Projector name and perform a search. The IP Address can be input directly. Also, provided the Projector name to be connected has been registered on the DNS server, you can perform a search simply by inputting that Projector name.s p.42 • Performing a search based on a Profile Once you have performed a search for a projector on a different subnet by specifying either an IP Address or a Projector name, you can save the search as a Profile with an easy-to-remember name, and then use that Profile whenever you subsequently want to search for a projector on a different subnet.s p.43 q If a search fails to find a projector, the most likely causes are as follows. Proceed as appropriate, depending on the cause of the failure. • For both Windows and Macintosh If there is no wireless LAN signal or if the signal is weak, check whether there is anything that could be interfering with the signal. • When the optional supplied or optional Wireless LAN unit is installed in the projector, and Macintosh is connected to a Wireless LAN Check whether AirPort is set to On. Or, check whether an appropriate access point has been selected.