Epson 1945W Quick Setup - Page 3
Project over a wired network
View all Epson 1945W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
4 Replace the wireless LAN module stopper and secure it using the screw you removed. 5 Close the air filter cover. 6 To configure your projector for your wireless network, do one of the following: • If you're using the optional Quick Wireless Connection USB key, insert it into the projector's USB-A port, look for the displayed message, remove the key, and connect it to a USB port on your computer. Follow the on-screen instructions to install the driver, then run your presentation. For details, see the online User's Guide. • If you're not using the key, continue with the steps bbelow. 7 Press the Menu button on the remote control, select the Network menu, and press . Project over a wired network Follow the steps here to configure your projector for your wired network using the projector's menu system. 1 Plug in and turn on the projector. 2 Press the Menu button on the remote control, select the Network menu, and press . 3 Select Network Configuration and press . 4 Select the Basic menu and press . 8 Choose Network Configuration and press . 9 Select the Wireless LAN menu and press . 5 Select the Projector Name setting and enter a name (up to 16 characters long) to identify your projector over the network. Use the displayed keyboard to enter characters. Press the arrow buttons on the remote control to highlight the characters and press to select them. Note: See the online User's Guide for information on adding passwords. 6 Select the Wired LAN menu and press . 10 Click Quick or Advanced, and enter your network's SSID. 11 If your network assigns addresses automatically turn on DHCP. If not, turn off DHCP and enter the projector's IP Address, Subnet Mask, and Gateway Address, as needed. To enter numbers, use the arrow buttons on the remote control to highlight a number, then press the button. When you're finished entering an address, highlight Return, then press . 12 To prevent the SSID and IP address from appearing on the network standby screen, set the SSID Display and/or IP Address Display settings to Off. 13 See "Install network software" for additional instructions. 7 Choose IP Settings and press . 8 If your network assigns addresses automatically, select IP Settings and turn on the DHCP setting. If not, turn off the DHCP setting and enter the projector's IP Address, Subnet Mask, and Gateway Address, as needed. 9 To prevent the IP address from appearing on the network standby screen, set the IP Address Display setting to Off. 10 When you are finished, select Complete and press again to save your settings. , then press 11 Press the Menu button to exit the menu system. 12 See "Install network software" for additional instructions.