Epson 570e Transition Guide - Page 6

Control Panel Font lights (3 LEDs) Indicate which font is selected. If all lights are on, one of the "Others" fonts is selected. See page 7. Condensed light On when condensed mode is on. LF/FF button Feeds paper line by line when pressed once. Ejects a single sheet or advances continuous paper to the next top-of-form position when held down. Paper Out light On when no paper is loaded in the selected paper source or paper is not loaded correctly. Flashes when paper has not been fully ejected or a paper jam has occurred. Font button Selects the font. Condensed button Turns condensed mode on and off. Tear Off/Bin button Advances continuous paper to the tear-off position. Feeds continuous paper backward from the tear-off position to the top-of-form position. Selects a cut-sheet feeder bin when the cut-sheet feeder is installed. Turns on Card mode to print on postcards and envelopes. Load/Eject button Loads a single sheet of paper. Ejects a single sheet of paper if a sheet is loaded. Loads continuous paper from the standby position. Feeds continuous paper backward to the standby position. Pause button Stops printing temporarily, and resumes printing when pressed again. When pressed for 3 seconds, turns on the Micro Adjust mode.* To turn off, press again. Pause light On when the printer is paused. Flashes when the printer is in the Micro Adjust mode.* Flashes when the print head has overheated. Tear Off/Bin lights f f when continuous paper is in the tear-off position. o n when bin 1 of the optional cut-sheet feeder is selected. n o when bin 2 of the optional cut-sheet feeder is selected. n n when the printer is in Card mode. *Micro Adjust mode When you hold down the Pause button for 3 seconds, the printer enters the Micro Adjust mode. (Make sure the Pause light is flashing.) In this mode, you can press the LF/FFD and Load/EjectU buttons to adjust the top-of-form or tear-off position. n = On f = Flashing o = Off 6