Epson 6100i Installation Guide - ELPMBUNI Universal Mount Assembly - Page 18

ELPMBUNI Final Adjustments 1. With the projector secured in the mount and power on and signal supplied to the projector you can now proceed with the final height, tilt, and roll and yaw to optimize the projected image. 2. The height can be adjusted by slightly loosening the two 8mm height adjustment screws and raising or lowering the projector (Figure 14). 3. Once the height is achieved tighten the two screws. 4. To adjust the tilt angle of the projector, slightly loosen the side M8 screws and tilt to the desired angle to the screen and firmly tighten the two M8 tilt adjustment screws (Figure 15). 5. If roll adjustment is needed to square the images on the screen, slightly loosen the front and rear M8 screws and adjust to the desired angle then firmly tighten the two M8 roll adjustment screws (Figure 16). Wood Stud Ceiling Allen Wrench Height Adjustable Screws (Roll) Adjusting Screws Allen Wrench Installation Manual Figure 14 Figure 15 Wood Stud Ceiling Tilt Adjusting Screws Allen Wrench Wood Stud Ceiling Figure 16 Page - 19 -