Epson 7800p Product Information Guide - Page 7

EPSON PowerLite 7800p Projector You see the currently selected source displayed in the main window, as shown below. All other sources (including the currently selected source) are displayed in smaller preview windows on the right side and at the bottom. Currently selected source Computer (Analog-RGB) Computer BNC DVI Video S-Video Preview windows If no equipment is connected to a port, or if there is no incoming signal, the preview window for that source appears blank. Note: Movies are displayed as still images on the preview screen. 2. Press the corresponding Source buttons on the remote control to switch to the desired source. Or press the ESC button to exit the preview screen without switching sources. Note: A red highlight surrounds the preview window for the currently selected source. You can use the pointer button on the remote control to highlight a different source, and then press Enter to display it. Troubleshooting Display Problems You Can't Project an Image If you see a blank screen or a blue screen with the No Signal message, try the following: ❏ Make sure the cables are connected correctly. ❏ Make sure the P power light is green and not flashing and the lens cover is off. ❏ If you've connected more than one computer and/or video source, you may need to press one of the Source buttons on the projector's control panel or the remote control to select the correct source. (Allow a few seconds for the projector to sync up after pressing the button.) ❏ If you're using a PC laptop, press the function key on your keyboard that lets you display on an external monitor. It may be labeled CRT/LCD or have an icon such as . You may have to hold down the Fn key while pressing it. Allow a few seconds for the projector to sync up after changing the setting. The Projector and Laptop Don't Display the Same Image If you're projecting from a laptop, and you don't see the same image on the projection screen and on your computer screen, follow these guidelines. If you're using a PC laptop: ❏ On most systems, there's a function key that lets you toggle between the LCD screen and the projector, or display on both at the same time. It may be labeled CRT/LCD or with an icon such as . You may have to hold down the Fn key while pressing it. Allow a few seconds for the projector to sync up after changing the setting. ❏ If the function key doesn't permit you to display simultaneously on both screens, you should check your monitor settings to make sure both the LCD screen and the external monitor port are enabled. From the Control Panel, open the Display utility. In the Display Properties dialog box, click the Settings tab, then click Advanced. The method for adjusting the settings varies by brand; you may need to click a Monitor tab, then make sure the external Monitor port is set as your primary display and/or enabled. See your computer's documentation or online help for details. If you're using Macintosh OS X: You may need to set up your system to display on the projector screen as well as the LCD screen. Follow these steps: 1. From the Apple menu, select System Preferences, then select Displays. 2. Make sure the VGA Display dialog box is selected. 3. Click the Arrange tab. Select the VGA Display dialog box Click the Arrange tab Make sure Mirror Displays is checked 4. Make sure the Mirror Displays checkbox is selected. 6 - EPSON PowerLite 7800p Projector 5/03