Epson B-510DN Start Here - Page 1

Start Here B-310N/B-510DN Before using the printer, make sure you read the safety instructions in the User's Guide on your printer CD. 1 Unpack 3 Install cartridges 1 Open the cartridge cover. 2 Unpack the 4 ink cartridges. If anything is missing, contact Epson as described on the back of this sheet. The following instructions apply to both the B-310N and B-510DN, unless otherwise noted. Note: The appearance of your printer may differ from what you see here, depending on your model and accessories installed. Remove all the tape and other packing material, including tape on the duplexer at the back of the printer. Insert the paper cassette into the printer. 3 Shake each cartridge for about 5 seconds. 4 Make sure the cartridge lever is all the way up, then install each cartridge in the correct slot for its color. 2 Turn on the printer 1 Connect the power cable. Note: Do not connect to the computer at this time. 2 Press the button. *411826000* *411826000* The arrow mark should be on top and pointing toward the printer. Push each cartridge in until it clicks. Cartridge lever 5 After you install all 4 cartridges, lower the cartridge lever to the locked position. 6 Close the cartridge cover. The printer starts charging the ink. This takes about 5 minutes. Caution: Don't turn off the printer or open any covers while it is charging or you'll waste ink. Note: The printer ships with full cartridges and part of the ink from this first set of cartridges is used for charging the printer.