Epson BrightLink 696Ui Installation Guide - Ultra-Short Throw Wall Mount ELPMB - Page 4
Installation Location
View all Epson BrightLink 696Ui manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Installation Location • Before installing the projector, verify the power supply wiring for the installation location. • Install the projector away from other electric devices such as fluorescent lights or air conditioners. Some kinds of fluorescent lights could interfere with the remote control of the projector. • Install the projector away from direct sunlight and other bright light sources. • It is recommended to keep VGA computer cable length less than 65 feet (20 meters) to reduce external noise. • Install the projector at an angle of no more than 3° horizontally or vertically in relation to the projection surface. • Install the projector in a location where the projected image is within reach. • The projector must be installed in one of the following locations in order for the Touch Unit to function properly (if applicable): • Mounted on a wall or suspended from the ceiling with images projected from in front of the screen. • Mounted vertically on a table with images projected from the front of the table. If using this installation method, you need the optional interactive table mount (ELPMB29). • When powering the Control Pad using batteries (if applicable), verify that the installation location meets the following conditions: • Install the Control Pad on the same surface as the projection screen. If the projection screen and the Control Pad installation point are uneven, install the Control Pad approximately 8 inches (20 cm) from the edge of the screen. • Make sure there are no obstacles between the Control Pad and the projector (not including the Touch Unit). • Use the optional remote control cable set (model ELPKC28, part number V12H005C28) to supply power to the Control Pad in the following situations: • The required conditions above are not met. • The projection screen and the Control Pad installation point are uneven and the difference in height is more than 2 inches (5 cm). • The projector is placed on a table and projecting to the screen. • Multiple projectors are being used. 4