Epson BrightLink 710Ui Start Here - Page 6

Calibration Calibration coordinates the position of the pen or your finger with the location of your cursor. If the pen or finger position and cursor location don't match, you can perform auto calibration, or you can calibrate manually for even greater accuracy. Note: You must perform pen calibration before calibrating finger touch. Pen Calibration 1 To start pen calibration, press the User button on the remote control, or press the Home button and select Auto Calibration. 2 When you see the Auto Calibration screen, do one of the following: •• Press to run auto calibration, then wait until calibration is complete. •• Select No, then press and follow the steps below to calibrate manually. 3 Select Manual Calibration, then press . 4 When you see the Manual Calibration screen, press to select Yes. 5 Touch the center of the circles on the screen with your pen to perform manual calibration. Note: Make sure you touch the center of each circle; otherwise the calibration may not be accurate. Finger Touch Calibration Note: If you are unable to perform finger touch calibration, make sure that the installer properly installed the Touch Unit and performed the angle adjustment. 1 To start finger touch calibration, press the User button on the remote control, or press the Home button and select Auto Calibration. 2 W hen you see the Auto Calibration screen, select No, then press and follow the steps below. 3 Select Touch Unit Setup, then press . 4 Select Touch Calibration, then press . 5 When you see the Touch Calibration screen, press to select Yes. A green circle appears in the upper left corner of your projected image. 6 Touch and hold the center of the circle with your finger until the circle disappears and another one appears. Note: Make sure you touch the center of each circle; otherwise the calibration may not be accurate. 7 Continue until all of the circles disappear. For more detailed instructions, see the online BrightLink User's Guide. Need Help? Telephone Support The Epson® PrivateLine® service is for you! All you have to do is call (800) 637-7661. This service is available for the duration of your warranty period. You may also speak with a projector support specialist by dialing (562) 276-4394 (U.S.) or (905) 709-3839 (Canada). Support hours are 6 am to 8 pm, Pacific Time, Monday through Friday, and 7 am to 4 pm, Pacific Time, Saturday. Days and hours of support are subject to change without notice. Toll or long distance charges may apply. Online Support To access the online User's Guide, get FAQs, and more, visit www.epson.com/brightlinkdownloads (U.S.) or www.epson.ca/brightlinkdownloads (Canada) and select your product. EPSON is a registered trademark and EPSON Exceed Your Vision is a registered logomark of Seiko Epson Corporation. BrightLink and PrivateLine are registered trademarks of Epson America, Inc. Mac is a trademark of Apple Inc., registered in the U.S. and other countries. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. Epson disclaims any and all rights in those marks. This information is subject to change without notice. © 2017 Epson America, Inc., 8/17 CPD-54265 Printed in XXXXXX