Epson C82N Start Here Card - Page 1
Epson C82N - Stylus Color Inkjet Printer Manual
UPC - 010343845039
View all Epson C82N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
EPSON Stylus C82N EPSON Stylus® C82N Start Here 2 Power On 1 Plug the printer's power cord into a grounded electrical outlet. 2 Press the printer's power button until the green power light comes on. Power button CAUTION: Use only the printer's power button to turn the printer on or off. 3 Load Ink 1 Lower the printer's output tray and open the cover. CPD-15266 1 Unpack 1 Remove everything from the box. Printer Basics Supplement booklet Printer Paper support AC adapter and power cord for print server Printer software CD-ROM Print server Ink cartridges 2 Remove all the blue tape and packing material inside and around the printer. The tape may be in slightly different places on your printer, so check carefully. 2 Shake the package of ink cartridges four or five times. Then remove the cartridges from the package. (Don't shake them after removing the packaging.) Don't touch the green circuit boards or remove any labels 3 Lower each ink cartridge into its holder with the green circuit board facing the back. Then gently push each ink cartridge down until it is firmly seated. The color of the cartridge label should match the marker on the holder. 4 Press the ink button and close the printer cover. 3 Slide the paper support into the grooves on either side of the sheet feeder. The paper support should fit securely. Ink button The green power light flashes as your printer charges ink for about 90 seconds. CAUTION: Don't turn off the printer while the green power light is flashing unless the printer hasn't moved or made any noise for more than 5 minutes. 4 Load Paper 1 Fan a few sheets of paper and place them against the right edge guide. Don't push the paper in. Don't load paper above this arrow 2 Slide the left edge guide against the paper, but not too tightly. 3 Pull out the output tray extensions. 5 Connect the Print Server 1 Turn off the printer. 2 Plug the print server into the printer's parallel port. Squeeze the wire clips together until they lock in place on either side of the connector. 3 Connect the network cable to the 10/100 connector on the print server, and then connect the other end of the cable to a hub or switch. Use a Category 5 twisted pair straight-through cable with RJ45 connectors. Print server NOTE: The print server will automatically use DHCP to obtain an IP address. If it cannot get an IP address this way, it will use the private IP address of 192.168.192.168. 10/100 connector DCIN connector 4 Plug the AC adapter into the DCIN connector on the print server. Connect the AC adapter's power cord to the AC adapter. 5 Plug the power cord of the AC adapter into a grounded electrical outlet. The lights on the print server will turn on. Status sheet button STATUS light DATA light 6 Press and hold down the status sheet button on the print server, and then turn on the printer. Continue to hold down the status sheet button for about 5 seconds. The STATUS light turns red as the print server initializes, while the DATA light beneath it stays green. NOTE: It can take up to one minute to initialize the print server. When it is done initializing, its STATUS light turns green or orange. 7 When the print server is done initializing, press the status sheet button again for about two seconds to print a report that is two pages long. If the status report prints, the print server is installed correctly. CAUTION: Before disconnecting the print server from the printer, always turn off the printer and unplug the AC adapter. Turn over