Epson MovieMate 50 Quick Guide - Page 15

The picture is wider at the top or bottom. You've tilted MovieMate to raise or lower the image, causing it to become "keystoned." Use the or buttons on the control panel or remote control to correct the problem. If you are unable to correct the distortion, you may need to reduce the degree of tilt. The picture is taller on the left or right side. MovieMate is set at an angle to the screen. Face it squarely toward the screen. The remote control doesn't work. ■ Make sure the toggle switch is in the correct position: set to -123 to use the numeric buttons, or to Func.- to use the other functions of these buttons. ■ Make sure you're within 19 feet of MovieMate, and within range of its front or back sensor (approximately 30° left or right, and 15° above or below). ■ You may need to replace the remote control's batteries. Make sure they're inserted with the positive (+) and negative (-) ends positioned as shown in the battery compartment. ■ Some DVDs don't support all of the remote control's functions. ■ If you're using a "universal" remote control, it might not work with MovieMate. Epson does not support any third-party remote controls. Solving Problems 15