Epson Perfection 3200 Pro Product Information Guide - Page 3

EPSON Perfection 3200 Series Using the Transparency Unit To use the transparency unit, remove the reflective document mat by grasping the top of the mat and sliding it up gently, as shown. remove mat by sliding it up transparency unit Using Film Holders Film has two sides, a shiny base side and a dull emulsion side. The base side of the film has the film maker's name and film ID numbers printed on it. Place the shiny base side down. To scan 35-mm film strips, 4 × 5-inch film, or 120/220 (6 × 9cm) film, place the film in the correct holder: 35-mm strips Make sure the cable for the tranparency unit is plugged into the round connector. If not, turn off the scanner, then connect the cable as shown. You may need to raise the scanner cover and twist the cable to insert it. make sure that the arrow faces up 4 × 5-inch and 120/220 (6 × 9-cm) film Place the holder with the film onto the scanner. Make sure the white triangle on the holder points to the upper-right corner of the scanner's document table. 11/02 EPSON Perfection 3200 Series - 3