Epson PowerLite 1980WU Quick Setup - Page 3

4 Replace the wireless LAN module stopper and secure it using the screw you removed. 5 Close the air filter cover. 6 To configure your projector for your wireless network, do one of the following: • If you're using the optional Quick Wireless Connection USB key, insert it into the projector's USB-A port, look for the displayed message, remove the key, and connect it to a USB port on your computer. Follow the on-screen instructions to install the driver, then run your presentation. For details, see the online User's Guide. • If you're not using the key, continue with the steps below. 7 Press the Menu button on the remote control, select the Network menu, and press . 8 Choose Network Configuration and press . 9 Select the Wireless LAN menu and press . 12 If you chose the Advanced connection mode, select IP settings and press . If your network assigns addresses automatically, turn on DHCP. If not, turn off DHCP and enter the projector's IP Address, Subnet Mask, and Gateway Address, as needed. To enter numbers, use the arrow buttons on the remote control to highlight a number, then press the button. When you're finished entering an address, highlight Finish, then press . Press Esc. 13 To prevent the SSID and IP address from appearing on the network standby screen, set the SSID Display and IP Address Display settings to Off. 14 When you're finished selecting settings in the Wireless LAN menu, press Esc. 15 If you are connecting the projector to a secure network, select the Security menu and press . Then select settings and press Esc when you're finished. 16 Select Complete and press save your settings. , then select Yes and press again to 17 See "Install network software" for additional instructions. Project over a wired network Follow the steps here to configure your projector for your wired network using the projector's menu system. 1 Plug in and turn on the projector. 2 Press the Menu button on the remote control, select the Network menu, and press . 10 Choose Connection Mode, press , select Quick (for a direct connection to a computer, tablet, or smartphone) or Advanced (for a connection to a router or access point), then press again. When you're finished, press Esc to return to the Wireless LAN menu. 11 If you chose the Advanced connection mode, select SSID, press and enter your network name (SSID) on the screen that appears. 3 Select Network Configuration and press . 4 Select the Basic menu and press . • To select a number or character, use the arrow buttons on the remote control to highlight it, then press . • To switch between uppercase and lowercase letters, select CAPS and press . • To change the displayed symbols, select SYM1 or SYM2 and press . When you're finished entering the SSID, select Finish and press . 5 Select the Projector Name setting and enter a name (up to 16 characters long) to identify your projector over the network. Use the displayed keyboard to enter characters. Press the arrow buttons on the remote control to highlight the characters and press to select them. Note: See the online User's Guide for information on adding passwords.