Epson PowerLite 713c Product Information Guide - Page 4

EPSON PowerLite 503c/713c Projector 5. Press the red Power button on top of the projector. Power button 2. Click the Arrange icon. click here power light drag one monitor icon on top of the other The power light flashes green as the projector warms up, and the projection lamp comes on in about 30 seconds. Then the power light stays green. Warning: Never look into the lens when the lamp is on. This can damage your eyes, and is especially dangerous for children. 6. Do one of the following: ❏ If you're using a computer, turn it on or restart it. In a few moments, you should see your computer display projected. (Windows® only: If you see a message saying that it has found a plug-and-play monitor, click Cancel.) ❏ If you're projecting a video, press the Source button on top of the projector to switch to your video source, and press the Play button on your DVD player or other device. If a projected image fails to appear, see the next section for help. What To Do If You See a Blank Screen If you see a blank screen or a blue screen with the message No Signal after turning on your computer or video source, try the following: ❏ Make sure the cables are connected correctly. ❏ Make sure the power light is green and not flashing and the lens cover is off. ❏ Try restarting your computer. ❏ Press the Source button on top of the projector to select the correct source. (Allow a few seconds for the projector to sync up after pressing the button.) If you're using a Macintosh laptop: You may need to set up your system to display on the projector screen as well as the LCD screen. Follow these steps: 1. From the Apple menu, select Control Panels, then click Monitors and Sound. 3. Drag one monitor icon on top of the other. If the Arrange option isn't available, you may need to select one of the Simulscan resolution settings: 1. Click the Monitor icon if necessary. Click here select a Simulscan resolution 2. Select a Simulscan resolution as shown. (Allow a few seconds for the projector to sync up after making the selection.) If you're using a PC laptop: ❏ Hold down the Fn key and press the function key that lets you display on an external monitor. It may have an icon such as or it may be labelled CRT/LCD. Allow a few seconds for the projector to sync up after pressing it. Check your laptop's manual or online help for details. On most systems, the or CRT/LCD key lets you toggle between the LCD screen and the projector, or display on both at the same time. ❏ Depending on your computer's video card, you might need to use the Display utility in the Control Panel to make sure that both the LCD screen and external monitor port are enabled. See your computer's documentation or online help for details. 4 - EPSON PowerLite 503c/713c Projector 9/01