Epson PowerLite 965 Operation Guide - EasyMP Multi PC Projection - Page 50
Network, Network Configuration, Wireless LAN, Configuration, IP Settings, Wireless LAN Power, Wireless
View all Epson PowerLite 965 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
• Set the computer, the access point, and the projector to the same SSID. Go to Network > Network Configuration > Wireless LAN > SSID. • Set DHCP to Off. When DHCP is set to On, it may take some time to enter LAN standby status if an available DHCP server is not found. Go to Network > Network Configuration > Wireless LAN > DHCP or Network > Network Configuration > Wireless LAN > IP Settings > DHCP. • Set the IP address, the subnet mask, and the gateway address for the projector correctly. • Set Wireless LAN Power to On. Go to Network > Network Configuration > Wireless LAN > Wireless LAN Power. • Set the wireless LAN system to meet the standards supported by the access point. Go to Network > Network Configuration > Wireless LAN > Wireless LAN system or Wireless LAN Sys. • When you enable the security setting, set the same passphrase to the access point, the computer, and the projector. • Close network settings on the projector, and then return to the LAN standby screen. • Check the computer's network settings. • If the wireless LAN adapter is not installed on your computer, install a wireless LAN card on your computer. • Enable the wireless LAN setting or AirPort on your computer. • Connect to the access point to which the projector is connected. • Turn off the firewall. If you do not want to turn it off, register the firewall as an exception. Make the necessary settings to open the ports. The ports used by this software are "3620", "3621", and "3629". • Check the access point settings. • Set connection permission at the access point to allow projectors to connect if any functions that block connections, such as MAC Address restrictions and port restrictions, are set to the access point. • Check the software settings. • Select the network adapter you are using from Switch LAN on the Set options screen. If the computer has multiple LAN environments, a connection cannot be established unless the network adapter is selected correctly. 50