Epson PowerLite Home Cinema 8500 UB User's Guide - PowerLite Home Cinema 8100 - Page 21
Making Other Connections, is in use.
View all Epson PowerLite Home Cinema 8500 UB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Making Other Connections Connect the power cable and other cables described below, depending on how you plan to use the projector. ■ Plug the power cable into the projector and a grounded electrical outlet. ■ The Trigger out port outputs a 12-volt DC signal when the projector is turned on. This lets a central control system monitor whether the projector is on or off, and can be used to raise or lower your projection screen automatically when the projector is in use. Connect a 3.5-mm mini jack to the port, as shown. Use the Trigger Out setting to enable the port (see page 47). ■ To use an AV controller with the projector, connect a 9-pin null modem serial cable to the RS-232C port. Refer to the table of ESC/VP21 command codes on page 70. Setting Up the Projector 21