Epson Stylus COLOR 777i Start Here Card - Page 1
Epson Stylus COLOR 777i - Ink Jet Printer Manual
View all Epson Stylus COLOR 777i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
SSTTAARRTTHHEREERE EEPPSSOONN®® SSttyylluuss®® CCoolloorr777777//777777ii Set Up the Printer Unpack Everything Your printer comes with the items shown here. Make sure you've also got a USB or parallel cable (not included) to connect your printer. See the Windows® or Macintosh® "System Requirements" in the Printer Basics book. paper support ink cartridges Printer Basics CD-ROM Remove all the tape and packing material from the inside and outside of your printer. Be sure to check inside and all around the printer for tape and packing materials. printer Install the Ink Cartridges Follow these ink cartridge precautions and the others in your Printer Basics book: • Use the cartridges packed with your printer the first time you install ink cartridges or your printer won't charge properly. • Install both ink cartridges, and leave them installed for all types of printing, or the printer won't work. • Remove the yellow tape seal from the ink cartridges or you'll permanently damage them. Don't remove the clear seals from the bottom or ink will leak out. • Don't touch the green chips on the cartridges. This prevents normal operation and printing. • Never turn off the printer when the power light is flashing, unless the printer hasn't moved or made any noise for more than 5 minutes. Keep ink cartridges out of the reach of children and do not drink the ink. If ink gets on your skin, wash the area thoroughly with soap and water. If ink gets in your eyes, flush them immediately with water. 1 Lower the printer's output tray and open the cover. Install the Ink Cartridges Don't place the printer in areas: • with high temperature or humidity • in direct sunlight or dusty conditions • with poor ventilation • near sources of heat or electromagnetic interference, such as a cordless telephone base unit Follow all the "Important Safety Instructions" listed in the Printer Basics book. Put On the Paper Support Locate the paper support slots on the back of the printer above the ports. Position the paper support so it curves as shown here, then slide it into the slots. (Don't place it in the paper feeder.) Connect the Printer Connecting to a USB Port (Recommended connection for Windows 98, Windows 2000, or Macintosh) 1 Make sure the printer and computer are turned off. paper support slots 2 Connect the square end of the USB cable to your printer's USB connector and the flat end of the cable to your computer's USB connector or a first tier USB hub. If you're using a USB hub, connect the printer's cable to the first tier of the hub or you may experience communication errors. If the printer doesn't work with the hub, connect it directly to a USB port. Connecting to a PC Parallel Port 1 Make sure the printer and computer are turned off. 2 Connect the larger end of the parallel cable to your printer's parallel port. Then secure it with the wire clips. 3 Connect the other end of the cable to your computer's parallel port and secure it as necessary. If your computer has multiple parallel ports, connect your printer to the built-in one (LPT1). To use a different port, see your Windows help. Configure your computer to match your printer's maximum speed by enabling ECP/DMA mode, if possible. See your computer documentation. Turn On the Printer 1 Plug the printer's power cord into a grounded electrical outlet. Don't use an outlet that can be turned off by a wall switch or timer, or one on the same circuit as a large appliance. This could damage the printer's power supply. 2 Press the power button to turn on the printer. The power light flashes and the error light comes on. The ink cartridge holders move into loading position. Always use the power button to turn the printer on or off. Never use an external switch, such as a power strip switch. 2 Lift up the two ink cartridge clamps. 3 Unwrap the ink cartridges, then remove only the yellow part of the tape seal on top. Don't pull off the blue part. black ink cartridge color ink cartridge Don't touch the green chips 4 Tilt each cartridge forward slightly as you lower it into its holder. Hang the tabs on the back of the ink cartridges on the hooks on the holder clamps. Don't place the cartridges under the holder clamp hooks; you may damage the clamp when you close it. 5 Close the ink cartridge clamps. 6 Press the ink cartridge replacement button to begin charging the ink delivery system, then close the printer cover. Charging takes about two minutes. The power light flashes and the printer makes various sounds until it's finished. Don't turn off the printer or interrupt charging or it will start over, using more ink than necessary. Charging is finished when the power light stops flashing and stays on. Turn over CPD-10841