Epson Stylus Photo User Setup Information
Epson Stylus Photo - Ink Jet Printer Manual
 |
View all Epson Stylus Photo manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson Stylus Photo manual content summary:
- Epson Stylus Photo | User Setup Information - Page 1
EPSON® Stylus Photo printer . . . Unpack the Printer Remove any packing material from the printer, as described on the Notice Sheet in the box. Save all the packaging so you can use it if you need to transport the printer later. You'll find these items inside: paper support black ink cartridge - Epson Stylus Photo | User Setup Information - Page 2
Attach the Paper Support Insert the paper support in the top slot on the back of the printer. Plug In the Printer First make sure the power is off. Caution: Do not plug the printer into an outlet controlled by a wall switch or timer, or on the same circuit as a large appliance. This may disrupt - Epson Stylus Photo | User Setup Information - Page 3
1. Lower the output tray and raise the printer cover. 2. Press the power button to turn on the printer. The power light flashes, the and ink out lights come on, and the ink cartridge holders move to the installation position. 3. Pull up the two ink cartridge clamps. Caution: You must remove the - Epson Stylus Photo | User Setup Information - Page 4
holders with the labels face up and the arrows pointing toward the back of the printer. Warning: If ink gets on your hands, wash them thoroughly with soap black ink cartridge ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ and water. If ink gets in your eyes, flush them immediately with water - Epson Stylus Photo | User Setup Information - Page 5
Load the Paper 1. Slide the left edge guide all the way left and pull out the output tray extensions. Note stack with the printable surface face up. Push the paper against the right edge guide. ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ arrow ○ mark Note: Don't load paper above the arrow mark inside the - Epson Stylus Photo | User Setup Information - Page 6
a nozzle check pattern. 3. When it's finished, turn off the printer. If you have any problems with the test, see Chapter 6 in your User's Guide for more information. Connect the Printer to Your Computer You can connect your EPSON Stylus™ Photo to either an IBM® compatible PC or an Apple® Macintosh - Epson Stylus Photo | User Setup Information - Page 7
driver software on diskettes or download it through your modem. Check out EPSON's Home Page at http://www. epson.com. For more information, see your User's Guide Introduction. 1. Turn on the printer first, then your computer. Make sure Windows 95 or Windows 3.1 is running. If the Windows 95 New - Epson Stylus Photo | User Setup Information - Page 8
the EPSON Digital Darkroom main screen, click INSTALL PRINTER DRIVERS. Then follow the instructions on the screen to install your printer driver software printer port on your Macintosh, make sure AppleTalk is inactive. EPSON is a registered trademark and EPSON Stylus is a trademark of SEIKO EPSON
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Quick Setup
Unpack the Printer
Here’s how to set up your new EPSON
®
Stylus Photo
printer . . .
Remove any packing material from the printer, as described on
the Notice Sheet in the box. Save all the packaging so you can
use it if you need to transport the printer later. You’ll find these
items inside:
4007082
Place the printer flat on a stable desk near a grounded outlet.
Leave plenty of room in back for the cables and enough room
in front for opening the output tray.
Do NOT put the printer:
In an area with high temperature or humidity
In direct sunlight or dusty conditions
Near sources of heat or electromagnetic interference, such
as loudspeakers or cordless telephone base units.
Also, be sure to follow the Safety Instructions in the
Introduction of your
User’s Guide.
black ink
cartridge
color ink
cartridge
paper
support