Epson Stylus Pro 7500 Product Information Guide - Page 7
SelecType Menu Map, Printing a Status Check, EPSON Stylus Pro 7000 series - 7 - ink
View all Epson Stylus Pro 7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
EPSON Stylus Pro 7000 series Message/Light PAPER NOT STRAIGHT/ Paper Out light flashing PAPER OUT/ Paper Out light on RELOAD PAPER/ Paper Out light on REMOVE PAPER/ Paper Out light on SECURE PAPER LEVER/Paper Out light on SERVICE REQ. / All lights flashing SERVICE REQ. 00000100/ All lights flashing TURN PWR OFF AND ON UNABLE TO PRINT Explanation Paper slipped and fed into the printer at an angle. No paper is loaded. Paper ran out. Paper could not be reversed into the printing position. Image is too wide for the paper loaded in the printer. Paper is not fully ejected. PAPER NOT CUT error was cleared. Paper is too thick for print head cleaning. Paper set lever was released. An error has occurred. The waste ink system is full. This message appears after you clear a paper jam. You tried to print a test pattern while an error condition was present. Response Reload paper, making sure the edges are straight and aligned with both rows of holes. Load paper. Remove any printouts or paper remaining in the printer and load more paper. If the message appears during a print job, reset the printer by pressing the Pause button for 3 seconds. Then load paper and resend the job. Remove the paper. Reload it so that the right and bottom edges are straight and aligned with both rows of holes. Resize your image or load wider paper. Cut the paper at the paper insertion slot, then reload paper. Reload paper. Push the paper set lever down to remove the paper. Print head cleaning automatically starts. After cleaning, reload paper. Pull the paper set lever all the way up. Restart print job for best results. Note the error number, and turn the printer off and then on. If the message remains, contact EPSON. Contact EPSON for service. Turn the printer off and then on again. After 3 seconds, the message disappears. Press the Pause button to exit SelecType mode. If the message appears again, clear the error before you print. SelecType Menu Map The following illustration shows the SelecType™ menus, along with the settings available for each one. PRINTER SETTING MENU: PLATEN GAP PAGE LINE INTERFACE PARA. I/F CODE PAGE PARPOERLLSMIZAERCGHECK PAPINEIRT.APLAIGNNELCHK ROLL MARG INIT. PANEL TEST PRINT MENU: NOZZLE CHECK STATUS CHECK READY PRINTER STATUS MENU: VERSION INK LEFT-K INK LEFT-C INK LEFT-M INK LEFT-LC INK LEFT-LM INK LEFT-Y CUTTER LIFE TOTAL PRINTS WASTE INK CR MOTOR PF MOTOR HEAD UNIT CLEANER HEAD ALIGNMENT MENU: PAPER THICK. ADJUST. PATT. #1 #2 #3 #4 #5 #6 #7 #8 #9 #10 #11 #12 CUTTER REPLACE MENU: CUT. REPLACE OPEN LOWER COVER REPLACE CUTTER CLOSE LOWER COVER PAPER CONFIG. MENU: PAPER NUMBER THICK. PAT. PAPER THICK. NO. DRSYUICNTGIOTINME Printing a Status Check The status check shows the current default settings, amount of ink remaining in each cartridge, page count, and the status of various printer parts. Follow these steps to print the status check: 1. Load a sheet of paper in the printer. (You can print test pages on roll paper, but you will use more paper.) 2. Press the SelecType button on the control panel. Press it repeatedly until you see TEST PRINT MENU on the display. 3. Press the Item button until you see STATUS CHECK=PRINT on the display. 8/00 EPSON Stylus Pro 7000 series - 7