Epson WorkForce Pro WF-3730 Start Here - Installation Guide - Page 2

3 Install ink cartridges Caution: Keep the ink cartridges out the reach of children and do not drink the ink. 1 Lift up the scanner unit until it locks. 6 Lower the scanner unit. Caution: Do not touch the flat, white cable. 2 Gently shake the ink cartridges. 3 Unpack the ink cartridges. 4 Remove only the yellow tape from each ink cartridge. 7 If prompted, follow the instructions on the LCD screen. The printer starts charging the ink. Ink charging takes approximately 5 minutes. When you see a completion message on the printer's LCD screen, charging is complete. Caution: Don't turn off the printer or raise the scanner unit while the printer is charging or you'll waste ink. Note: • The printer is designed for use with Epson cartridges only, not third-party cartridges or ink. • The cartridges included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. • As part of setup, your product's serial number will be sent to a secure Epson server so that you can be eligible to participate in programs we may offer from time to time, including the Epson ink replenishment program. You will have a separate opportunity to consent to participating in such programs. 4 Load paper 1 Make sure the product is done charging the ink, and then close the control panel, lift the output tray, and pull out a paper cassette. Caution: Do not remove any other labels or seals, or ink will leak. Do not touch the green chip on the cartridge. 5 Insert the cartridge in the holder for each color. Press each cartridge down until it clicks. Make sure all cartridges are pushed down into place. 2 Slide the side edge guides all the way out and set the front edge guide to the paper size you are using.