Epson WorkForce Pro WF-4820 Start Here - Installation Guide - Page 2
Load paper, WF-3820, WF-4820/WF-4830 - all in one printer
View all Epson WorkForce Pro WF-4820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
2 Gently shake the ink cartridges, and remove them from the packaging. 3 Remove only the yellow tape from each ink cartridge. 4 Load paper See the online User's Guide for information about loading capacity, available paper types and sizes, loading envelopes, and using the ADF. 1 Make sure the product is done charging the ink, and then lower the control panel, lift the output tray, and pull out the paper cassette. Caution: Do not touch the areas shown above. Doing so may prevent normal operation and printing. 4 Insert the cartridge in the holder for each color. Press each cartridge down until it clicks. Make sure all cartridges are pushed down into place. 2 Slide the side edge guides all the way out and set the front edge guide to the paper size you are using. 5 Lower the scanner unit. 3 Insert paper with the glossy or printable side down. 6 WF-3820: Follow the on-screen instructions to start charging the ink. WF-4820/WF-4830: Ink charging begins automatically. Ink charging takes approximately 5 minutes. When you see a completion message on the product's LCD screen, charging is complete. Caution: Don't turn off the printer or raise the scanner unit while the printer is charging or you'll waste ink. Note: As part of setup, your product's serial number will be sent to a secure Epson server so that you can be eligible to participate in programs we may offer from time to time, including the Epson ink replenishment program. You will have a separate opportunity to consent to participating in such programs. 7 Follow the on-screen instructions to select paper settings. Note: Make sure the paper is loaded against the front edge guide and not sticking out from the end of the cassette. 4 Slide the edge guides against the paper, but not too tightly. 5 Keep the cassette flat as you insert it all the way, then lower the output tray.