Epson WorkForce Pro WF-C5290 Start Here - Installation Guide for U.S. and Cana - Page 2
Load paper
View all Epson WorkForce Pro WF-C5290 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
3 Remove and discard the protective piece from the ink pack tray. 4 Shake an ink pack 10 times, then remove it from the packaging. 8 Press OK on the LCD screen to start charging the ink. Ink charging takes approximately 7 minutes. A message appears when ink charging is complete. 4 Load paper For instructions on loading envelopes, legal-size paper, or using the rear paper feed slot, see the online User's Guide. 1 Make sure the product is done charging the ink, then pull out the paper cassette. Note: Do not touch the green chip on the ink pack. 5 Move the handle forward, place the ink pack into the ink pack tray until it clicks, then move the handle back to its original position. 2 Slide the side edge guides all the way out and set the front edge guide to the paper size you are using. 3 Insert paper with the glossy or printable side down. Standard paper: Thick paper: Note: Make sure the ink pack is fully inserted and level with the top of the ink pack tray. 6 Insert the ink pack tray into the printer. Repeat steps 2 to 6 for the other ink packs. Note: The ink packs are keyed to fit into the correct color slot. If you cannot insert the ink pack tray all the way, do not force it. Make sure the ink pack color matches the color slot on the printer. Note: Make sure the paper is under the arrow mark for your paper type and loaded against the front edge of the cassette. 4 Slide the edge guides against the paper, but not too tightly. 7 Close the ink pack tray cover and lock it.