Epson WorkForce Pro WF-C529R Start Here - Installation Guide - Page 2

1 Unlock and open the ink pack tray cover. 6 Insert the ink pack tray into the printer. Repeat steps 2 to 6 for the other ink packs. 2 Press an ink pack tray to release it, then pull the tray out. Note: The ink packs are keyed to fit into the correct color slot. If you cannot insert the ink pack tray all the way, do not force it. Make sure the ink pack color matches the color slot on the printer. 7 Close the ink pack tray cover and lock it. 3 Remove and discard the protective piece from the ink pack tray. 4 Shake an ink pack 10 times, then remove it from the packaging. Note: Do not touch the green chip on the ink pack. 8 Select Installed on the LCD screen to start charging the ink. Ink charging takes approximately 9 minutes. A message appears when ink charging is complete. Caution: Don't turn off the product, raise the printer cover, or open the front cover while the product is charging or you'll waste ink. 4 Load paper For instructions on loading envelopes or legal-size paper, or using the rear paper feed slot, see the online User's Guide. 1 Make sure the product is done charging the ink, then pull out one of the paper cassettes. 5 Place the ink pack into the ink pack tray, move the handle forward, then move the handle back to its original position. Note: Make sure the ink pack is fully inserted and level with the top of the ink pack tray. 2 Slide the side edge guides all the way out and set the front edge guide to the paper size you are using.