Epson WorkForce Pro WF-M5299 Start Here - Installation Guide - Page 2
Load paper
View all Epson WorkForce Pro WF-M5299 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
3 Remove and discard the protective piece from the ink pack tray. 4 Shake the ink pack 10 times, then remove it from the packaging. Note: Do not touch the green chip on the ink pack. 8 Select OK on the LCD screen to start charging the ink. Ink charging takes approximately 7 minutes. A message appears when ink charging is complete. Caution: Don't turn off the printer, raise the printer cover, or open the ink pack tray cover while the printer is charging or you'll waste ink. 4 Load paper For instructions on loading envelopes, legal-size paper, or using the rear paper feed slot, see the online User's Guide. 1 Make sure the product is done charging the ink, then pull out the paper cassette. 5 Place the ink pack into the ink pack tray, move the handle forward, then move the handle back to its original position. 2 Slide the side edge guides all the way out and set the front edge guide to the paper size you are using. Note: Make sure the ink pack is fully inserted and level with the top of the ink pack tray. 6 Insert the ink pack tray into the printer. 7 Close the ink pack tray cover and lock it. 3 Insert paper with the glossy or printable side down. Standard paper: Thick paper: Note: Make sure the paper is under the arrow mark for your paper type and loaded against the front edge of the cassette. 4 Slide the edge guides against the paper, but not too tightly.