Epson XP-800 Start Here - Page 2

3 Remove the cap from each ink cartridge. Store the caps in the included plastic bag. N ote: Save the caps and use them to recap the ink cartridges after removing them for storage or disposal. 4 Insert the cartridges head first in the holder for each color. Press each cartridge down until it clicks. 5 Lower the scanner unit. 2 Pull on the front cover to pull out the lower paper cassette. lower cassette 3 Slide the edge guides to the sides of the paper cassette. 4 Set the front edge guide to the paper size you are using. Then insert paper with the glossy or printable side facedown. 6 The printer starts priming the ink. This takes about 6 minutes. When you see a completion message on the printer's LCD screen, priming is complete. Note: The cartridges included with the printer are designed for printer set up and not for resale. After some ink is used for priming, the rest is available for printing only in the same printer. C aution: Don't turn off the printer or raise the scanner unit while the printer is priming or you'll waste ink. 5 Load paper The printer has 2 paper cassettes and a rear paper feed slot. You can load the following paper sizes: • Upper cassette (Cassette 1): 4 × 6- or 5 × 7-inch photo paper. • Lower cassette (Cassette 2): letter-size, A4, legal-size, or 8 × 10-inch paper. (See the instructions below for loading paper in the lower cassette.) • Rear paper feed slot: one sheet at a time See the Quick Guide for instructions on loading paper in the upper cassette and rear paper feed slot. See the online User's Guide for available paper types, sizes, loading capacity, and instructions for loading legal-size paper, envelopes, and card stock. 1 Lower the front cover (if it's not open already). N ote: Make sure the paper is loaded against the edge guide and not sticking out from the end of the cassette. 5 Slide the edge guides against the paper, but not too tight. Make sure the paper is under the tabs on the edge guides. 6 Keep the cassette flat as you insert it. Note: The output tray will open automatically when you print.