Foxconn A7GM-S 2.0 English Manual. - Page 45
► OnBoard Floppy Controller, ► Serial Port1 Address, ► IR Address, ► IR Mode, ► IR Duplex Mode
View all Foxconn A7GM-S 2.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
3 SuperIO Configuration CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc. SuperIO Configuration SuperIO Configuration Help Item OnBoard Floppy Controller Serial Port1 Address IR Address IR Mode IR Duplex Mode [Enabled] Allows BIOS to enable [3F8/IRQ4] or disable floppy [2F8/IRQ3] controller. [IrDA] [Half Duplex] Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults ► OnBoard Floppy Controller This item is used to enable/disable Floppy Controller. ► Serial Port1 Address This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial port 1. ► IR Address This item is used to assign the I/O address and interrupt request (IRQ) for the IR port. ► IR Mode This item is used to set the IR mode. The available settings are : [IrDA] : An IrDA device for maximum 115200 bit/s. [ASK IR] : A faster IrDA for 1152000 bit/s. ► IR Duplex Mode This item enables you to determine the infrared function of the onboard infrared chip. 38